Assa Abloy Corbin Russwin ED5200N Series Installation Instructions Manual page 22

8 Mortise Exit Installation Instructions (Continued)
7 Install Head Cover
a. Lay device wire harnesses across ¾" hole (Fig. 14a).
b. Tuck wires into hole when installing cover so that wires are not pinched between
head cover and door.
c. Attach head cover using (2) #8-32 flat head screws (Fig. 14b).
d. Install scalp using (2) 8-32 flat head screws.
Fig. 14a
To complete installation, continue to Section 9 - IN120 / IN220 Installation Instructions
Use 3/4" hole to
tuck trim and
device wire
harness under
head cover
22
Copyright © 2016, 2019, 2021, ASSA ABLOY Access and Egress Hardware Group, Inc.
All rights reserved. Reproduction in whole or in part without the express written permission
of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
IN120 & IN220 Series
ED5200N / ED5600N Series
Exit Devices for 9100/9M100
Fig. 14b