Assa Abloy Corbin Russwin ED5200N Series Installation Instructions Manual page 25

IN120 & IN220 Series
ED5200N / ED5600N Series
Exit Devices for 9100/9M100
9 IN120 /IN220 Installation Instructions (Continued)
2 Installation of Connectors
CAUTION - Do not allow debris to enter connector contacts
Ensure connectors are covered with silicone dielectric compound
• Snip end of packet to dispense grease
• Ensure all connector pins and contacts (Fig. 16a)
are covered - do not overfill or over-apply**
*Supplied tube contains 5 grams of silicone dielectric compound (grease)
**Evenly distribute grease; full application requires approximately 2.5 grams
IMPORTANT: Do not run wires through bottom hole in plate (Fig. 16a, b) - it will
damage wires and the controller connector. Route wires around flange, do not
route wires through the flange hole (Fig. 16b).
Secure the following connectors (Fig. 16b, c):
A. Secure the 4-pin DPS connector.
B. Secure the 10-pin lock body assembly connector.
Secure Mounting Plate
• Tuck excess cable into wire hole on inside of door
• Secure the mounting assembly while ensuring proper
alignment of outside reader and fully tighten the (2)
through-bolts on the inside of the door to secure the
reader and plate to the door
C. Secure the 24-pin card reader connector (Fig. 16b, c).
D. Ensure all openings on back of secured reader connector
are covered completely with grease (Fig. 16c).
Copyright © 2016, 2019, 2021, ASSA ABLOY Access and Egress Hardware Group, Inc.
All rights reserved. Reproduction in whole or in part without the express written
permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Important Note: Before you secure the connectors
SILICONE DIELECTRIC
COMPOUND
(grease)*
Board-to-Board
Connector
25
APPLY
FILL
FILL
FILL
FILL
Fig. 16a
DPS
Reader
(4-pin)
(24-pin)
A
C
Fig. 16b
FILL
FILL
D
Fig. 16c
NO WIRES
THRU THIS
OPENING
B