Grandstream Networks HT801 Administration Manual page 39

Configuring HT801/HT802 Through Voice Prompts
As mentioned previously, The HT801/HT802 has a built-in voice prompt menu for simple device configuration.
Please refer to "Understanding HT801/HT802 Interactive Voice Prompt Response
how to access its menu.
DHCP MODE
Select voice menu option 01 to enable HT801/HT802to use DHCP.
STATIC IP MODE
Select voice menu option 01 to enable HT801/HT802 to use STATIC IP mode, then use options 02, 03, 04, and 05 to set up IP
address, Subnet Mask, Gateway, and DNS server respectively.
FIRMWARE SERVER IP ADDRESS
Select voice menu option 13 to configure the IP address of the firmware server.
CONFIGURATION SERVER IP ADDRESS
Select voice menu option 14 to configure the IP address of the configuration server.
UPGRADE PROTOCOL
Select the menu option 15 to choose firmware and configuration upgrade protocol between TFTP, HTTP, HTTPS, FTP, and
FTPS. The default is HTTPS.
FIRMWARE UPGRADE MODE
Select voice menu option 17 to choose firmware upgrade mode among the following three options: 1) Always check, 2) check
when pre/suffix changes, and 3) never upgrade.
Register a SIP Account
The HT801/HT802 supports 2 FXS ports which can be configured with 2 SIP accounts. Please refer to the following steps in
order to register your accounts via the web user interface:
1. Access your HT801/HT802 web UI by entering its IP address in your favorite browser.
2. Enter your admin password (default: admin).
3. Press Login to access your settings.
4. Go to FXS Port (1 or 2) pages.
5. In the FXS Port tab, set the following:
1. Account Active to Yes.
2. Primary SIP Server field with your SIP server IP address or FQDN.
3. Failover SIP Server with your Failover SIP Server IP address or FQDN. Leave empty if not available.
4. Prefer Primary SIP Server to No or Yes depending on your configuration. Set to No if no Failover SIP Server is defined.
If "Yes", the account will register to the Primary SIP Server when failover registration expires.
5. Outbound Proxy: Set your Outbound Proxy IP Address or FQDN. Leave empty if not available.
6. SIP User ID: User account information, provided by VoIP service provider (ITSP). Usually in the form of a digit similar
to a phone number or actually a phone number.
7. Authenticate ID: SIP service subscriber's Authenticate ID is used for authentication. Can be identical to or different
from SIP User ID.
8. Authenticate Password: SIP service subscriber's account password to register to the SIP server of ITSP. For security
reasons, the password will field will be shown as empty.
9. Name: Any name to identify this specific user.
Menu" for more information about IVR and