Grandstream Networks HT801 Administration Manual page 21

Enable OpenVPN®
OpenVPN® Server Address
OpenVPN® Port
OpenVPN® Interface type
OpenVPN® Transport
Enable OpenVPN® LZO Compression
OpenVPN® Encryption
OpenVPN® Digest
OpenVPN® CA
OpenVPN® Certificate
OpenVPN® Client Key
OpenVPN® Client Key Password
OpenVPN® username
OpenVPN® password
System Ring Cadence
Call Progress Tones:
Dial Tone
Ringback Tone
Busy Tone
Reorder Tone
Confirmation Tone
Call Waiting Tone
Prompt Tone
Conference Party Hangup Tone *
Special Proceed Indication Tone
Prompt Tone Access Code
Lock Keypad Update
Disable Voice Prompt
Disable Direct IP Call
Allow user to enable OpenVPN®. Default is No.
Specify the IP address or FQDN for the OpenVPN® Server.
Specify the listening port of the OpenVPN® server. Default is 1194
Specify the Interface type of OpenVPN® whether TAP or TUN. Default is TUN.
Specify the Transport Type of OpenVPN® whether UDP or TCP. The default is UDP.
Enable OpenVPN® LZO Compression. Default is Yes.
Select the OpenVPN® Encryption. Default is BF-CBC 128 bit (default key).
Select the OpenVPN® Digest. Default is SHA1.
Specifies the OpenVPN® CA. Maximum Character Number is 8192.
Specifies the OpenVPN® Certificate. Maximum Character Number is 8192.
Specifies the Client Key. Maximum Character Number is 8192.
Configures the OpenVPN® Client Key Password. Maximum Length is 64.
Configure the OpenVPN® username.
Configure the OpenVPN® password
Configuration option is set ring cadence on FXS port for all incoming calls.
Syntax: c=on1/off1-on2/off2-on3/off3; (3 cadences maximum)
Default is set to c=2000/4000; (US standards)
Using these settings, users can configure tone frequencies and cadence according
to their preference. By default, they are set to North American frequencies.
Configure these settings with known values to avoid uncomfortable high pitch
sounds. ON is the period of ringing ("On time" in 'ms') while OFF is the period of
silence. In order to set a continuous tone, OFF should be zero. Otherwise, it will ring
ON ms and a pause of OFF ms and then repeat the pattern.
Example configuration for N.A.
Dial tone:
f1=350@-13, f2=440@-13, c=0/0;
Syntax: f1=freq@vol, f2=freq@vol, c=on1/off1-on2/off2-on3/off3; [...]
(Note: freq: 0 – 4000Hz; vol: -30 – 0dBm)
* "Conference Party Hang-up Tone" will apply only if the "Special Feature" is set to
"MTS".
Special Proceed Indication Tone: This feature allows user to configure the tone
played when user goes offhook and there is voicemail on the subscribed mailbox.
Need to set 'MWI Tone' to 'Special Proceed Indication Tone' to use this feature.
Key pattern to get Prompt Tone. Maximum 20 digits.
Configuration update via keypad (analog phone connected to FXS port keypad using
IVR menu) is disabled if set to Yes.
Voice prompt is disabled if set to Yes.
Direct IP call is disabled if set to Yes.