Grandstream Networks HT801 Administration Manual page 13

Provisio
Displays provisioning status.
n
Provides generated core dump file if unit malfunctions.
Core
Dump
Clean will be displayed if no issues.
Click on "Test Page" to be redirected to the
GR909
lines tests page (Hazardous Potential, Foreign Electromotive Forces, Resistive Faults, Receiver Off-hook
and Ringer Equivalent Number)
Basic Settings Page Definitions
Basic Settings
New End User Password
Confirm End User Password
New Viewer Password
Confirm Viewer Password
Web Session Timeout
Web Access Attempt Limit
Lockout time interval
Web Access Mode
HTTP Web Port
HTTPS Web Port
Disable SSH
SSH Port
SSH Idle Timeout
Table 8: Status Page Definitions
Configures user level password. Case sensitive and max. Length of 25 characters.
Note : The new Password must contain 8-20 characters, at least one number, one
uppercase, and a lowercase letter. Purposely not displayed for security reasons.
Re-enter the end user password to confirm change user password on web GUI to
avoid typo or mistakes.
Configures viewer-level password. Case sensitive and max. length of 25 characters.
Note : The new Password must contain 8-20 characters, at least one number, one
uppercase, and a lowercase letter. Purposely not displayed for security reasons.
Re-enter the viewer password to confirm change viewer password on web GUI to
avoid typo or mistakes.
Configure timer to logout web session during idle. Default is 10 min. Range is 2-60
min.
Configure attempt limit before lockout. Default is 5. Range is 1-10.
If login attempt failed 5 times, login would be locked out for the time length. (Default
15 mins. Range 1-15 min).
Allows users to choose the Web Access Mode between "HTTPS", "HTTP" and
"Disabled". If "Disabled" is selected, web UI access will be disabled.
By default, "HTTP" is selected.
Customizes HTTP port used to access the HT801/HT802 web UI. Default is 80.
Customizes HTTPS port used to access the HT801/HT802 web UI. Default is 443.
Enables/disables the SSH access. Default is No (enabled).
Allows users to self-configure SSH Port number.
By default, the port number is 22.
Configures SSH session timeout. [0 – 86400] seconds; Default is 0.