5-10.
Hot-Swap Unit
Preparation
1.
Remove the top panel assembly. (Refer to
2.
Remove the Power unit assembly. (Refer to
Procedure
1.
Disconnect the harness from the connector of the hot-swap unit.
2.
Remove the two screws (PSW 3 x 6).
3.
Slide the hot-swap unit in the direction of the arrow, then release the positioning pin from the notch of the hot-
swap unit.
Note
Do not pull up the hot-swap unit without releasing the notch of the hot-swap unit from the positioning pin. Doing
so may damage the positioning pin.
Hot-swap unit
Connector
Notch
Positioning pin
Harness
4.
Install the removed parts by reversing the steps of removal.
PWS-110RX1A
"5-4. Top Panel
Assembly".)
"5-9. Power
Unit".)
PSW 3 x 6
5-14