4.
Confirm that the power unit has been locked. (The power unit cannot be drawn out by pulling the handle without
pulling up the lever.)
Rear of this unit
Power unit
5.
Align the hole to the boss, attach the rear panel (power), and then tighten the four screws.
Note
First tighten the screw (a), and then tighten the other three screws. (Refer to the figure below.)
Rear of this unit
Hole
B3 x 8
PWS-110RX1A
Boss
Rear panel (power)
assembly
(a)
B3 x 8
Power unit
Handle
Lever
5-13