Sw-1627 Board - Sony PWS-110RX1A Service Manual

5-7.

SW-1627 Board

Preparation
1. Remove the top panel assembly. (Refer to
2. Remove the front panel assembly. (Refer to
Procedure
1. Open the wire saddle (C) and disconnect the harness from the connector (CN100) on the SW-1627 board.
2. Remove the two screws, then remove the bracket (SW) assembly in the direction of the arrow.
3. Remove the SW-1627 board from the two pins of the bracket (SW) assembly.
SW-1627 board
PSW3 x 6
4. Install the removed parts by reversing the steps of removal.
PWS-110RX1A
"5-4. Top Panel Assembly".)
"5-5. Front Panel
CN100
Harness
Assembly".)
Wire saddle (C)
Bracket (SW)
assembly
Pins
5-10