If-1330 Board - Sony PWS-110RX1A Service Manual

5-20.

IF-1330 Board

Preparation
1. Remove the top panel assembly. (Refer to
2. Remove the fan duct (110). (Refer to
3. Remove the CN-3698 board. (Refer to
4. Remove the RC holder assembly. (Refer to
5. Remove the SSD module. (Refer to
6. Remove the iAP-005 board assembly. (Refer to
Procedure
1. Remove the four screws, the four step washers and the four compression springs and detach the heat sink.
Step washers
Compression springs
Heat sink
Note
At the time of the installation, tighten the screws to the specified torque in the following sequence: (a), (b), (c),
(d).
2. Remove the five screws, and then remove iAP-005 CPU board from the connectors on the IF-1330 board.
PWS-110RX1A
"5-4. Top Panel
"5-12. Fan Assembly".)
"5-14. CN-3698
"5-11. HPR-48
"5-16. SSD Module
"5-17. iAP-005 Board
B2.6 x 5
(c)
(b)
(a)
(d)
Assembly".)
Board".)
Board".)
(M.2)".)
Assembly".)
5-33