5-22.
MB-1204 Board
Preparation
1.
Remove the top panel assembly. (Refer to
2.
Remove the RC holder assembly. (Refer to
3.
Remove the CN-3698 board. (Refer to
4.
Remove the iAP-005 board assembly. (Refer to
Procedure
1.
Open the wire saddle (C) and disconnect the fine-wire coaxial cable from the connector (CN102) on the MB-1204
board.
Note
When pulling out the fine-wire coaxial cable, pull out the connector part with your fingers.
2.
Disconnect all harnesses connected to the MB-1204 board.
PWS-110RX1A
"5-4. Top Panel
Assembly".)
"5-11. HPR-48
Board".)
"5-14. CN-3698
Board".)
"5-17. iAP-005 Board
Assembly".)
CN701
CN702
CN703
CN704
CN705
Wire saddle (C)
CN103
CN602
CN601
CN600
CN102
CN200
CN700
CN807
CN201
CN202
5-36