Iap-005 Board Assembly - Sony PWS-110RX1A Service Manual

5-17.

iAP-005 Board Assembly

Preparation
1. Remove the top panel assembly. (Refer to
2. Remove the fan duct (110). (Refer to
3. Remove the CN-3698 board. (Refer to
4. Remove the RC holder assembly. (Refer to
Procedure
1. Remove the four screws, and then remove the rear panel (power) assembly.
2. Remove the rear panel assembly.
Rear of this unit
Note
When installing the rear panel (power) assembly, observe the following instructions.
• Align the boss (A) with the hole (A).
• First tighten the screw (a) shown in the illustration, and then tighten the other three screws.
Note
When installing the rear panel assembly, align the three bosses (B) with the three holes (B).
3. Open the three pieces of wire saddle (C).
4. Disconnect the two harnesses from the connectors (CN201, CN807) on the MB-1204 board.
5. Disconnect the harness from the connector (A) of the iAP-005 board assembly.
PWS-110RX1A
"5-4. Top Panel
"5-12. Fan Assembly".)
"5-14. CN-3698 Board".)
"5-11. HPR-48
Bosses (B)
Hole (B)
Rear panel assembly
Assembly".)
Board".)
Boss (A)
Holes (B)
Hole (A)
B3 x 8
Rear panel (power)
assembly
(a)
B3 x 8
5-25