Sony PWS-110RX1A Service Manual page 64

Procedure
1. Slide the PCI board support in the direction of the arrow A.
HPR-48 board
Note
• The PCI board support is hard to slide because it is locked tightly enough not to disengage by vibration. On
installation, slide the PCI board support in a way that the corner of the HPR-48 board is fitted to the groove
of the portion A as shown in the illustration.
• There is a hole on the side panel to check if the PCI board support is installed correctly. When the PCI board
support is locked, it appears in blue in the hole. On installation, when the PCI board support is not seen in
the hole, slide it until it is seen in the hole.
PCI board support check hole
PWS-110RX1A
PC I board support
A A
PCI board support
Corner of the
HPR-48 board
Portion A
PCI board support
PC I board support
Portion A
Rear of this unit
5-16