Auto-Close & Accessories; Auto-Close - B&D Smart Pro SDO-9V3 Installation Instructions Manual

Smart Pro, Smart & Secure installation instructions
14. Auto-Close & Accessories

14.1 Auto-Close

Auto-Close mode is a function that automatically closes the door after a pre-set time. Safety beams must be installed
in order to run the Auto-Close function. There are two types of Auto-Close available:
i. Standard auto-close - the door will Auto-Close after a programmed time. In this mode the timer starts to
countdown as soon as the door is fully open. This function is useful in case the safety beam does not get
triggered.
NOTE: Auto-Close will not function if the door reversed after hitting an obstruction or stalling.
ii. Safety Beam triggered auto-close - the door will auto-close after a programmed time. In this mode the timer
starts counting down only when the safety beam is triggered. ie car leaving the garage.
WARNING! It is compulsory to have
Safety Beams installed when using
Auto-Close mode.
T O E N A B L E T H E A U T O - C L O S E F U N C T I O N
S T E P O N E
Remove controls
cover
T O E N A B L E T H E A U T O - C L O S E F U N C T I O N
S T E P T W O
S T E P O N E
Remove controls
Press
until gear LED
cover
repeatedly
ashes
x 2 PE Auto
x 3 Std Auto
Value options = Indicated by brightness
S T E P F O U R
S T E P T W O
Parameter 1
Press to move through
Press
until gear LED
options as per table
repeatedly
ashes
PE AUTO-CLOSE x2 OFF
x 2 PE Auto
AUTO-CLOSE x3 OFF
x 3 Std Auto
S T E P F O U R
Press to move through
options as per table
Press till gear LED
repeatedly ashing
S T E P T H R E E
Press to enter
parameter
Default setting for
Press till gear LED
Auto-Close is OFF.
repeatedly ashing
of main light
S T E P T H R E E
OR
Press to enter
parameter
2 3 4
Press to save Press to leave
unchanged
15sec 30sec 60sec
Default setting for
Auto-Close is OFF.
15sec 30sec 60sec
OR
Press to save Press to leave
unchanged
5 6
90sec -
90sec 120sec
14