Clearing The Door Limit Positions; Re-Profiling The Door; Controller Memory Reset - B&D Smart Pro SDO-9V3 Installation Instructions Manual

Smart Pro, Smart & Secure installation instructions
NOTE: If unhappy with the speed or travel limit setting,
restart this procedure by resetting the door limit positions
as per below first.

12.2 Clearing the Door Limit Positions

C L E A R I N G T H E D O O R L I M I T P O S I T I O N S
S T E P O N E
Remove controls cover
Press till gear
repeatedly LED lit
S T E P T H R E E
The BLUE LED ashes
continuously to show
limits cleared

12.3 Re-profiling the Door

R E - P R O F I L I N G T H E D O O R
Re-pro ling is a simple way of re-learning the travel
tip
characteristics of a previously setup Limit Switch
travel. Re-pro ling is used when travel characteristic
change due to mechanical adjustments.
To initiate a re-pro le: LIMITS must already be set.
S T E P O N E
Remove controls cover
Press till gear
repeatedly LED lit
S T E P T H R E E
Press
to exit
S T E P T W O
Release when
HOLD
light stops
for 10 sec
ashing
NOTE: No action taken within
30 secs, the opener returns to
original settings.
SET Close & Open limits
S T E P T W O
HOLD
for 2 secs
Door will open
and close
Then re t
OFF
controls cover

12.4 Controller memory reset

To clear the controller:
C O N T R O L L E R M E M O R Y R E S E T
If limits are already set, clear limits rst by following
tip
Clearing the door limit positions and then follow
below.
S T E P O N E
When in limit setting mode
The BLUE LED ashes
continuously to show
limits clear
This will cause all control memory to be set to factory defaults
EXCLUDING: transmitters, history log and cycle counters.
12
S T E P T W O
Release
HOLD
for 10 sec