Fit The Opener; Bracket Position - B&D Smart Pro SDO-9V3 Installation Instructions Manual

Smart Pro, Smart & Secure installation instructions

6. Fit the Opener

6.1Secure C-Rail to Opener:
a. Remove the Opener from the box, taking care of antenna (if fitted).
b. Remove the track and hardware kit from the rail box.
c. Locate and insert the shaft of drive unit
d. Fix the two track brackets
e. Place drive unit back in packing box for protection.
1
8

7. Bracket Position

7.1Wall Bracket Position:
a. Determine the centre of the door and mark this point with a line on the
wall above.
b. Raise the door and find the highest point of travel of the first (top) door
panel.
WARNING! The Opener must be securely fastened to structural
supports, otherwise opener failure may ensue causing serious
personal injury and / or property damage.
c. Using step ladder and a level, transfer this height to the wall above the
door and mark a line 60mm above it, across the centre line.
DO NOT DO IT YOURSELF: If sufficient structural support can
DIY
not be found, contact a door profressional for installation.
7.2 Mounting the Wall Bracket:
a. Draw two lines extending 21.5mm from each side of the centre point.
b. Centre the wall bracket
Mark centres for at least two holes and ensure it is into a solid mounting
point.
c. Drill holes in the wall with an appropriate bit.
d. Secure to the wall using:
i. IF CONCRETE OR BRICK:
8mm (5/6") loxins/dynabolts.
ii. IF TIMBER:
wood screw #20 or similar (min. 50mm).
7.3 Attach the Track to the Wall Bracket
a. Leave the drive unit in its packing box on the floor for protection and
lift the other end of the C-Rail.
b. Attach the pre-assembled track
90mm long pin and secure with the supplied pin snap
7h
into the C-Rail's
1
with four (4) M4 x 8 screws
7a
Locate shaft into
the sprocket
over the intersection of these two lines.
7e
to the wall bracket
8
sprocket.
8
supplied in accessory pack.
7k
7k
7a
7h
with the
7e
.
7f
WARNING!
DO NOT use tek screws
to affix rail. Only use
the screws provided,
and fix these into the
threaded holes in the
chassis.
60mm
8
7f
7e
7
Level
7e