Servo/Spindle Motor Power Cable - Mitsubishi Electric MDS-EX-CV Series Specifications And Instruction Manual

MDS-EX-CV/CVH Series Specifications and Instruction Manual
14 Appx.3: EMC Installation Guidelines
14.5 Measures for Various Cables

14.5.3 Servo/Spindle Motor Power Cable

Power cable for servo motor
Control panel
10cm or less
To drive unit
Power cable for spindle motor
Control panel
10cm or less
To drive unit
 Use four wires (3-phase + earthing) for the power cable that are completely shielded and free from breaks.
 Earth the shield on both the control panel side and motor chassis side. The shield earth position on the drive unit side must
be 10cm or less from the control panel.
 Earth the shield with a metal P clip or U clip.
(A cable clamp fitting can be used depending on the wire size.)
 Directly earth the shield. Do not solder the braided shield onto a wire and earth the end of the wire.
 When not using a shield cable for the power cable, use a conventional cabtyre cable. Use a metal conduit outside the
cable.
 Earth the power cable on the control panel side at the contact surface of the conduit connector and control panel.
(Mask the side wall of the control panel with paint.)
 Follow the treatment shown in the example for the conduit connector to earth the power cable on the motor side.
(Example: Use a clamp fitting, etc.)
IB-1501700-A
Earth with P or U clip
As close
Cannon
as possible
connector
Servo motor
Shield cable
Using shield cable
Earth with P or U clip
As close
Terminal box
as possible
Spindle motor
Shield cable
Using shield cable
Earth example with P clip Earth example with U clip
Clamp fitting
Conduit
Conduit connector
Control panel
Earth with paint mask
Conduit connector
To drive unit
Conduit
Cabtyre cable
Using conduit
Earth with paint mask
Control panel
Conduit connector
To drive unit
Conduit
Cabtyre cable
Using conduit
Solder
Earth example with wire soldering
Earth
(Wire it as short and thick as possible.)
Connector
82
Cannon
connector
Servo motor
Terminal box
Spindle motor