Mitsubishi Electric MDS-EX-CV Series Specifications And Instruction Manual page 6

 Injury prevention
When handling a motor, perform operations in safe clothing.
In the system where the optical communication with CNC is executed, do not see directly the light generated
from CN1A/CN1B connector of drive unit or the end of cable. When the light gets into eye, you may feel
something is wrong for eye.
(The light source of optical communication corresponds to class1 defined in JISC6802 or IEC60825-1.)
The linear servo motor, direct-drive motor and built-in IPM/SPM spindle motor uses permanent magnets in
the rotor, so observe the following precautions.
[Handling]
- The linear servo motor, direct-drive motor and built-in IPM/SPM spindle motor could adversely affect medical elec-
tronics such as pacemakers, etc., therefore, do not approach the rotor.
- Do not place magnetic materials as iron.
- When a magnetic material as iron is placed, take safety measure not to pinch fingers or hands due to the magnetic
attraction force.
- Remove metal items such as watch, piercing jewelry, necklace, etc.
- Do not place portable items that could malfunction or fail due to the influence of the magnetic force.
- When the rotor is not securely fixed to the machine or device, do not leave it unattended but store it in the package
properly.
- When installing the motor to the machine, take it out from the package one by one, and then install it.
- It is highly dangerous to lay out the motor or magnetic plates together on the table or pallet, therefore never do so.
[Transportation and storage]
- Correctly store the rotor in the package to transport and store.
- During transportation and storage, draw people's attention by applying a notice saying "Strong magnet-Handle with
care" to the package or storage shelf.
- Do not use a damaged package.
[Installation]
- Take special care not to pinch fingers, etc., when installing (and unpacking) the linear servo motor.
Incorrect wiring could lead to smoke or fire in the unit and the reactor, resulting in faults. Be careful when
wiring.
WARNING