European Ec Directives; Cautions For Ec Directive Compliance - Mitsubishi Electric MDS-EX-CV Series Specifications And Instruction Manual

Table of Contents

MDS-EX-CV/CVH Series Specifications and Instruction Manual

13 Appx.2: Compliance to EC Directives

13.1 European EC Directives

In the EU Community and UK, the attachment of a CE mark and a UKCA mark (European CE marking/UK UKCA

Regulations) is mandatory to indicate that the basic safety conditions of the Machine Directives (issued Jan. 1995), EMC

Directives (issued Jan. 1996), Electromagnetic Compatibility Regulations (issued Jan.2021), the Low-voltage Directives

(issued Jan. 1997), and the Electrical Equipment (Safety) Regulations (issued Jan. 2021) are satisfied. The machines and

devices in which the servo and spindle drive are assembled are the targets for European CE marking and UK UKCA

Regulations.

 Compliance to EMC Directives/Electromagnetic Compatibility Regulations

The servo and spindle drive are components designed to be used in combination with a machine or device. These are not

directly targeted by the Directives, but a CE mark and a UKCA mark must be attached to machines and devices in which

these components are assembled. The next section "Appx.3: EMC Installation Guidelines", which explains the unit

installation and control panel manufacturing method, etc., has been prepared to make compliance to the EMC Directives/

Electromagnetic Compatibility Regulations easier.

 Compliance to Low-voltage Directives/Electrical Equipment (Safety) Regulations

Each unit is targeted for the Low-voltage Directives/Electrical Equipment (Safety) Regulations. An excerpt of the

precautions given in this specification is given below. Please read this section thoroughly before starting use.

For the EMC Directives/Electromagnetic Compatibility Regulations and Low-voltage Directives/Electrical Equipment

(Safety) Regulations, Self-Declaration Documents have been prepared.

Contact Mitsubishi or your dealer when required.

Use the Low-voltage Directive/Electrical Equipment (Safety) Regulations compatible parts for the servo/spindle drive and

servo/spindle motor. In addition to the items described in this instruction manual, observe the items described below.

 Configuration

Isolating

transformer

IB-1501700-A

Electromagnetic

Circuit breaker

contactor

AC reactor

Insert a type B circuit breaker (RCD) in the power supply side of the unit.

Unit

Table of Contents

Mds-ex-cvh series