Important Installation Notes - Nortel Remote Office 9110 Release Note

December 2003

Important installation notes

This section provides important information about the installation of the Remote
Office 9150 unit, Remote Office 911x series unit, Meridian Digital Telephone IP
Adapter unit, and RLC.
Advanced Configuration for upgrades
If you have changed the settings in the Advanced Configuration dialog box
(patch releases only), upgrading to product release 1.4.2 from a product release
prior to 1.4.1 returns the settings in this dialog box, listed below, to their default
values. For these default values, refer to page 64.
NLP
!
Dialtone/DTMF Relay
!
Access the Advanced Configuration dialog box through Configuration
Manager's RLC System Configuration property sheet to ensure that these fields
contain the proper settings for your system. For more information, refer to
"Advanced Configuration" and "Advanced Configuration settings" on pages 63
and 65, respectively, of these Release Notes. This information also appears in
the Remote Office Configuration Manager Help content for this dialog box.
If you are upgrading to product release 1.4.2 from product release 1.4.1, the NLP
and Dialtone/DTMF Relay settings are not set to their default values but instead
stay the same value as they were configured in product release 1.4.1.
Automatic TEIs (Terminal Endpoint Identifiers)
BRI modules must be used in a point-to-point configuration if using automatic
TEI assignments. They cannot be used in a multi-point configuration. You
should also make sure that no other ISDN devices are on the line.
1.4.2 Release Notes for Remote Office and RLC 19