Opening The Engine Guard; Lubrication; Greasing The Machine; Greasing The Front Caster Pivots - Toro GrandStand HDX 72514 Operator's Manual

Opening the Engine Guard

Rotate the engine guard forward as shown in
32.
Figure 32

Lubrication

Figure

Greasing the Machine

Grease with No. 2 lithium or molybdenum grease.
1. Disengage the PTO and set the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Clean the grease fittings with a rag.
Note:
front of the fitting(s).
4. Connect a grease gun to the fitting.
5. Pump grease into the fittings until grease begins
to ooze out of the bearings.
6. Wipe up any excess grease.
g425565
Greasing the Front Caster
Pivots
Service Interval: Yearly
Grease type: Lithium or molybdenum grease
1. Remove the dust cap and adjust the caster
pivots; refer to
Bearing (page
Note:
finished greasing the caster pivots.
2. Remove the hex plug.
3. Thread a grease fitting (1/4 inch–28 taper
thread) into the hole.
4. Pump grease into the fitting until it oozes out
around the top bearing.
5. Remove the grease fitting from the hole.
6. Install the hex plug and dust cap.
Greasing the Caster-Wheel
Hubs
Service Interval: Yearly
Grease type: Lithium or molybdenum grease
1. Park the machine on a level surface, disengage
the PTO, and engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Remove the caster wheel from the caster forks.
4. Remove the seal guards from the wheel hub
(Figure
29
Make sure to scrape any paint off the
Adjusting the Caster-Pivot
40).
Keep the dust cap off until you have
33).