Driving The Machine - Toro GrandStand HDX 72514 Operator's Manual

Driving the Machine

Important:
Back the machine over curbs, 1 wheel
at a time; driving it forward over curbs could
damage the machine.
CAUTION
Positioning one lever too far in front of the
other causes the machine to spin very rapidly.
As a result, you may lose control of the
machine, causing personal injury to you and
damage to the machine.
Slow down the machine before making sharp
turns.
1. Disengage the parking brake.
2. Move the motion-control levers down to the
center, unlocked position.
Figure 17
1. Front reference bar
2. Left control lever
3. Rear reference bar
3. Slowly push the motion-control levers forward or
rearward. Move 1 lever farther than the other
lever to turn.
Note:
The farther you move the motion-control
levers, the faster the machine moves in that
direction.
4. To stop, move the motion-control levers back to
the N position.
EUTRAL
g030983
4. Right control lever
5. Right control lever in the
N -L position
EUTRAL OCK
6. Left control lever in the
N -L position
EUTRAL OCK
20
Figure 18
g385716