Table of Contents
Advertisement
is sometimes difficult to measure the true
gap.
1. Feeler gauge
1. Feeler gauge
•
If the gap is less than 0.010 inch, then
install the shim.
•
If the gap is sufficient, proceed to the
safety check in step F.
F.
Perform the following safety check:
i.
Start the engine from the operator's
position.
ii.
Make sure that the blades do not
engage when the PTO switch is in
the O
disengaged.
Note:
disengage, install the shim.
iii.
Engage and disengage the PTO
switch 10 consecutive times to
ensure that the clutch is functioning
properly.
Checking the Wheel-Lug
Nuts
Service Interval: After the first 100 hours—Check the
wheel-lug nuts.
Figure 59
Figure 60
position and the clutch is
FF
If the clutch does not
Check and torque the wheel-lug nuts to 115 to 142
N∙m (85 to 105 ft-lb).
g302536
g302535
42
Advertisement
Table of Contents
