Toro GrandStand HDX 72514 Operator's Manual page 52

Checking the Mower Deck
Front-to-Rear Pitch
1. Adjust the tire pressure in the rear tires to the
correct specifications.
2. Position 1 blade front-to-rear. Measure at A and
B locations from a level surface to the cutting
edge of the blade tips
Note:
The mower blade should be 6 mm (1/4
inch) lower in front at A than in the rear at B.
3. Rotate the blades and repeat for other blades.
Figure 80
1. Measure the blade at
points A and B
4. If the front-to-rear pitch is not correct, refer to
Leveling the Mower Deck (page
(Figure 80).
g001041
2. Measure from a level
surface
52).
Leveling the Mower Deck
1. Loosen the jam nuts on the linkages you want
to adjust.
1. Top bolt
2. Jam nut
3. Yoke
4. Side nut
2. Rotate the adjuster on the lift arm to adjust the
height of the mower deck on that corner.
Note:
Rotate the adjuster clockwise to raise the
deck; rotate the bolt counterclockwise to lower it.
3. Tighten the jam nuts.
4. Check the side-to-side height; refer to
the Mower Deck Side-to-Side Height (page
5. Check the front-to-rear pitch; refer to
the Mower Deck Front-to-Rear Pitch (page 52)
52
Figure 81
5. Adjust these linkages
to adjust the rear of the
mower deck.
6. Adjust these linkages to
adjust the left side of the
mower deck.
7. Adjust these linkages to
adjust the front of the
mower deck.
8. Adjust these linkages to
adjust the right side of the
mower deck.
Checking
Checking
g404192
51).