Opening The Engine Guard; Lubrication; Greasing The Machine; Greasing The Torsion Idler - Toro GrandStand 71504 Operator's Manual

Opening the Engine Guard

Rotate the engine guard forward as shown in
34.
Figure 34

Lubrication

Figure

Greasing the Machine

Grease with No. 2 lithium or molybdenum grease.
1. Disengage the PTO and set the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Clean the grease fittings with a rag.
Note:
front of the fitting(s).
4. Connect a grease gun to the fitting.
5. Pump grease into the fittings until grease begins
to ooze out of the bearings.
6. Wipe up any excess grease.

Greasing the Torsion Idler

Service Interval: Yearly
g270363
Important:
Do not use general-purpose grease.
1. Open the engine guard; refer to
Engine Guard (page
2. Grease the torsion idler on the mower deck
using high-temperature grease at the grease
fitting shown in
1. Grease fitting
3. Close the engine guard; refer to
Engine Guard (page
29
Make sure to scrape any paint off the
Use only high-temperature grease.
29).
Figure 35.
Figure 35
29).
Opening the
g301302
Opening the