Table of Contents
Advertisement
Storage
Storage Safety
•
Before leaving the operator's position for any
reason, do the following:
– Park the machine on a level surface.
– Disengage the drives and the power take-off.
– Engage the parking brake.
– Shut off the machine and remove the key.
– Wait for all moving parts to stop.
– Allow the machine to cool before servicing,
adjusting, fueling, cleaning, or storing it.
•
Let the engine cool before storing the machine.
•
Do not store the machine or fuel near flames or
drain the fuel indoors.
Cleaning and Storage
1.
Disengage the power takeoff (PTO), engage the
parking brake, shut off the engine, and remove
the key.
2.
Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially
the engine.
Important:
You can wash the machine
with a mild detergent and water. Do not
pressure-wash the machine. Avoid excessive
use of water, especially near the drive system
and engine. Pressure-washing can force dirt
and water into critical parts, such as spindle
bearings and electrical switches.
3.
Clean any dirt and chaff from the outside of the
engine cylinder-head fins and blower housing.
4.
Check the brake; refer to
Brake (page
43).
5.
Service the air cleaner; refer to
Cleaner (page
31).
6.
Grease the machine; refer to
Machine (page
29).
7.
Change the engine oil; refer to
Engine Oil (page
8.
Check the tire pressure; refer to
Tire Pressure (page
9.
For long-term storage, do the following:
A.
Add fuel stabilizer/conditioner to the fuel in
the tank as directed by the fuel stabilizer
manufacturer.
B.
Run the engine to distribute the conditioned
fuel through the fuel system for 5 minutes.
Testing the Parking
Servicing the Air
Greasing the
Servicing the
32).
Checking the
40).
C.
Shut off the engine, allow it to cool, and
drain the fuel tank; refer to
Fuel Tank (page
until it shuts off.
D.
Start the engine and allow it to run until it
shuts off. Repeat with the choke engaged (if
applicable) until the engine does not start.
E.
Dispose of fuel properly; recycle it according
to local regulations.
Important:
stabilizer/conditioner longer than
the duration recommended by the
fuel-stabilizer manufacturer.
10.
Remove the spark plug(s) and check its
condition; refer to
(page
34).
11.
With the spark plug(s) removed from the engine,
pour 15 ml (2 tablespoons) of engine oil into the
spark-plug hole, and use the starter to crank the
engine and distribute the oil inside the cylinder.
12.
Install the spark plug(s) but do not connect the
wire to the spark plug(s).
13.
Check and tighten all fasteners. Repair or
replace any part that is damaged or missing.
14.
Paint all scratched or bare metal surfaces with
paint from an Authorized Service Dealer.
15.
Store the machine in a clean, dry, garage or
storage area. Remove the key from the switch
and store it in a memorable place. Cover the
machine to protect it and keep it clean.
55
Draining the
35), or operate the engine
Do not store fuel containing
Servicing the Spark Plug(s)
Advertisement
Table of Contents
