Servicing The Fuses - Toro GrandStand HDX 72514 Operator's Manual

Figure 49
1. Positive battery post
2. Negative battery post
Installing the Battery
1. Install the battery as shown.
Figure 50
2. Close the engine guard.
g000538
3. Red (+) charger lead
4. Black (-) charger lead
g403915

Servicing the Fuses

The electrical system is protected by fuses. It
requires no maintenance. If a fuse blows, check the
component or circuit for a malfunction or short.
1. Park the machine on a level surface, disengage
the PTO, and engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Release the operator cushion from the rear of
the machine.
4. If you need to access the charge fuse, remove
the fuel tank; refer to
(page 36).
5. Pull out the fuse and replace it
1. Key switch fuse (15 A)
2. Accessory port (15 A)
3. Power-takeoff (PTO) fuse
(10 A)
6. Install the fuel tank, if removed; refer to
Removing the Fuel Tank (page
7. Install the operator cushion.
38
Removing the Fuel Tank
(Figure 51).
Figure 51
4. Hour meter (7.5 A)
5. Charge fuse (20 A)
36).
g301335