Replacing The Transmission Belt; Controls System Maintenance; Adjusting The Motion-Control Levers - Toro GrandStand HDX 72514 Operator's Manual

Replacing the Transmission
Belt
Service Interval: Every 400 hours
Every 1,000 hours—Replace the transmission
belt.
1. Remove the fuel tank; refer to
Fuel Tank (page
2. Remove the tension spring.
CAUTION
The spring is under tension when
installed and can cause personal injury.
Wear safety glasses and be careful when
removing the spring.
Figure 65
1. Tension spring
3. Remove the deck belt from the clutch and clutch
stop.
Figure 66
1. Transmission belt
4. Install the new belt.
5. Install the tension spring.
Removing the
36).
Controls System
Maintenance
Adjusting the
Motion-Control Levers
If the motion-control levers do not align horizontally,
adjust the motion-control levers.
1. Park the machine on a level surface, disengage
the PTO, and engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Push the motion-control levers down out of the
N -
EUTRAL
4. Check if the right motion-control lever aligns
horizontally with the left motion-control lever
(Figure 67).
g405395
1. Left motion-control lever in
the Neutral-lock position
2. Left motion-control lever
3. Right motion-control lever
in the Neutral-lock position
Note:
To adjust the right motion-control lever
horizontally, adjust the cam.
5. Release the cushion from the rear of the
machine.
6. Loosen the nut holding the cam
g405426
45
position (Figure 67).
LOCK
Figure 67
4. Check the horizontal
alignment here
5. Right motion-control lever
g425655
(Figure 68).