Table of Contents
Advertisement
4.
Move both bypass levers fully rearward.
Figure 26
5.
Disengage the parking brake.
6.
Push the machine to the desired location.
Important:
Always push the machine by
hand. Do not tow the machine, because
hydraulic damage may occur.
7.
Immediately after moving the machine, engage
the parking brake.
8.
Move both bypass levers fully forward.
Figure 27
Transporting the Machine
Use a heavy-duty trailer or truck to transport the
machine. Use a full-width ramp. Ensure that the trailer
or truck has all the necessary brakes, lighting, and
marking as required by law. Please carefully read all
the safety instructions. Knowing this information could
help you or bystanders avoid injury. Refer to your
local ordinances for trailer and tie-down requirements.
WARNING
Driving on the street or roadway without
g412793
turn signals, lights, reflective markings, or a
slow-moving-vehicle emblem is dangerous
and can lead to accidents, causing personal
injury.
Do not drive the machine on a public street
or roadway.
WARNING
Loading a machine onto a trailer or truck
increases the possibility of backward tip-over
and could cause serious injury or death.
• Use only full-width ramps; do not use
individual ramps for each side of the
machine.
• Ensure that the length of ramp is at least 4
times as long as the height of the trailer or
truck bed to the ground.
• Use extreme caution when operating a
machine on a ramp.
g412918
• Back the machine up the ramp and walk it
forward down the ramp.
• Avoid sudden acceleration or deceleration
while driving the machine on a ramp as
this could cause a loss of control or a
tip-over situation.
25
Advertisement
Table of Contents
