Table of Contents
Advertisement
EN
NL
3.10
Arm pad depth (option 2)
Adjust the depth of the arm pad as follow (range 120 mm: step less):
1. Loosen both socket screws (35) at the bottom of the arm pad.
2. Move the arm pad to the front or rear within the
range of the slotted holes (42,5 mm).
If this not enough, remove the socket screws and
attach the arm pad using the other holes (3
positions available).
3. Tighten both socket screws firmly.
4. Repeat this for the second arm pad. Make sure
both arm pads are positioned identically.
3.11
Armrest height (option 3)
The height of the armrest is adjustable in 6 positions as follows:
1. Pull the armrest out of the armrest holder.
2. Remove the socket screw (36) that sets the height.
3. Mount the screw in the desired hole.
4. Insert the armrest in the armrest holder.
5. Check the height; readjust if necessary.
6. Repeat this for the second armrest. Make sure both armrests
are positioned identically.
3.12
Side plate adjustment (option 4)
6
5
4
Wheel position
A
B
C
D
3
2
1
A
B
C
D
Backrest screw
1
2
3
3
Installation manual
The height of the side plate can be adjusted in 3
positions as follows:
1. Remove socket screws (backrest screw &
seat screw).
2. Move the side plate up/down to the desired
height and retighten it with the socket
screws in the corresponding openings
according to the table below.
Repeat the adjustments above for the second
side plate.Make sure that both side plates are
set to the same height and dept, and that they
are firmly secured.
Seat screw
4
5
6
6
- 16 -
V-series wheelchairs
2023-02
Adjustments
35
36
Advertisement
Table of Contents
