Hide thumbs Also See for V100:

Advertisement

VERMEIREN
V100
I N S T R U C T I O N M A N U A L

Advertisement

Table of Contents
loading

Summary of Contents for Vermeiren V100

  • Page 1 VERMEIREN V100 I N S T R U C T I O N M A N U A L...
  • Page 2 No part of this manual may be reproduced in any form what so ever (print, photocopy, microfilm or any other process) without written permission of the publisher, or processed, duplicated or distributed by using electronic systems. © N.V. Vermeiren N.V. 2011...
  • Page 3: Table Of Contents

    V100 2011-01 Contents Preface ....................2 Productdescription ..............3 Intended Use ........................ 3 Technical specifications ....................4 Drawing ........................5 Accessories ........................6 Location identification plate..................6 Explanation of symbols ....................6 Use ....................6 Carrying the wheelchair ....................6 Mounting the rear wheels ....................
  • Page 4: Preface

    First of all we want to thank you for putting your trust in us by selecting one of our wheelchairs. The Vermeiren wheelchairs are the result of many years of research and experience. During the development, special attention was given to the ease of use and the serviceability of the wheelchair.
  • Page 5: Productdescription

    When used on mats, carpeted floors or loose floor coverings, the floor covering can get damaged. Use only Vermeiren approved accessories. The manufacturer is not liable for damage caused by the lack of or improper service or as a result of not following instructions from this manual.
  • Page 6: Technical Specifications

    V100 2011-01 Technical specifications Technical terms below are valid for the wheelchair in standard settings. If other footrest / arm support or other accessories are used, the tabulated values will change. Make Vermeiren Address Vermeirenplein 1/15, B-2920 Kalmthout Type Manual wheelchair...
  • Page 7: Drawing

    V100 2011-01 The wheelchair complies to the requirements set up in: ISO 7176-8: Requirements and test methods for static, impact and fatigue strengths. ISO 7176-16: Resistance to ignition of upholstered parts ISO 7176-19: Wheeled mobility devices for use as seats in motor vehicles.
  • Page 8: Accessories

    V100 2011-01 Accessories The following accessories are available for the V100: Anterior pelvic belt (B20) for mounting on the tubes of the back (see according • manual) Anti-tipping device (B78) for mounting on the bottom frame (see according manual) •...
  • Page 9: Mounting The Rear Wheels

    V100 2011-01 Mounting the rear wheels 1. Take the rear wheel and push on button 2. Keep the button pushed in and mount the rear wheels axle till it stops. 3. Release the button. 4. Check that the wheels is secured.
  • Page 10: Mounting Or Removing Of Arm Supports

    V100 2011-01 To apply the brakes: Push the brake handles forward till you feel a distinctive click. CAUTION: Risk of unintended movement – Make sure the wheelchair is on a flat horizontal surface before releasing the brakes. Never release both brakes simultaneously.
  • Page 11: Transfer In And Out The Wheelchair

    V100 2011-01 To open and remove the arm rest: 1. Press lever and pull the front of the arm rest upwards. 2. Fold the arm rest backwards. To remove the arm rest, press button and pull the rear of the arm support from tube hood f.
  • Page 12: Correct Position In The Wheelchair

    V100 2011-01 Correct position in the wheelchair Some recommendations for a comfortable use of the wheelchair: Position your backside as close as possible to the back rest. • Make sure your upper legs are horizontal – If needed adjust the length of the foot •...
  • Page 13 V100 2011-01 An experienced user can negotiate higher kerbs by himself. This is best done backwards. Turn the wheelchair to have the rear wheels facing the kerb. Lean forward to move your centre of gravity forward. Move the wheelchair close to the kerbs.
  • Page 14: Fold Up The Wheelchair

    V100 2011-01 2.11.3 Taking of stairs Taking of stairs while you staying in the wheelchair shall be according following rules: WARNING: Risk of tipping over – Taking of stairs shall always with 2 attendants. Remove the footrests. One attendant tip the wheelchair slightly backwards.
  • Page 15: Use Of The Wheelchair As Seat In A Motor Vehicle

    V100 2011-01 2.15 Use of the wheelchair as seat in a motor vehicle WARNING: The wheelchair has passed the crash of ISO 7176-19: 2008 and, as such, has been designed and tested for use only as forward-facing seat in a motor vehicle.
  • Page 16 V100 2011-01 figure 3 Steps to secure the wheelchair user: 1. Remove both arm rests. 2. If present, attach the wheelchair's pelvic belt. 3. Attach the occupant restraint belts according to the instructions of the strap-system manufacturer. 4. Wear the pelvic belt low across the front of the pelvis, so that the angle of the pelvic belt is within the preferred zone of 30°...
  • Page 17: Installation And Adjustment

    Accessories • Adjusting the seat height The Vermeiren V100 is adjustable in 3 seat heights by changing the wheels position. At each height there is a different setting of the front and rear wheels. WARNING: The top hole of the axle plate is not intended for mounting the rear axle - This hole is for mounting the drum brake.
  • Page 18: Adjusting The Seat Depth

    If installed properly the swivel axles of the front wheels and the ground must be perpendicular. Check this. Adjust the brakes according § 3.5. Adjusting the seat depth The Vermeiren V100 is adjustable in 2 seat depths by changing the cross. Seat depth Cross 450 mm (17.72 in.) Hole 1 and 3 430 mm (16.93 in.) (Standard)
  • Page 19: Adjust The Brakes

    V100 2011-01 Adjust the brakes WARNING: Risk of injury – Brakes may only be adjusted by your specialist dealer. Adjust the brakes according following rules: 1. Install the wheels according § 2.2. 2. Disconnect the brakes by pulling lever backwards.
  • Page 20: Adjusting The Arm Support

    The expected lifetime of this wheelchair amounts 8 years. Lifetime of the wheelchair is influenced by its use, storage, regular maintenance, servicing and cleaning. Regular Maintenance The maintenance activities to ensure a good condition for your Vermeiren wheelchair are described below: Before every ride •...
  • Page 21: Shipping And Storage

    Repairing and assembling of spare parts for your wheelchair may only be performed by the specialist dealer. Only authorized Vermeiren spare parts may be installed. Shipping and storage The shipping and storage of the wheelchair shall be according following instructions: Store in a dry place (between +5 °...
  • Page 22: Inspection

    V100 2011-01 Initially the zinc parts only require rubbing with a dry cloth. Stubborn dirt can best be removed by using a suitable commercial zinc polish. Inspection In principle we recommend one inspection every year, and a minimum of one before usage is resumed.
  • Page 23 V100 2011-01 Product name Laundry Surface Disinfection of excretions Area of Manufacturer or Active substance disinfection effectiv- Supplier disinfection 1 part sputum or stools + 2 parts eness (scrubbing- diluted solution or 1 part urine + 1 part /wiping diluted solution...
  • Page 24: Guarantee

    V100 2011-01 Guarantee Excerpt from the "General Business Conditions": (...) 5. The guarantee period for warranty claims is 24 months. As a result of our superior quality requirements, we can increase the time bar on warranty claims beyond these fundamental, statutory requirements for (...)
  • Page 25: Maintenance Plan

    V100 2011-01 Maintenance plan Date Maintenance Remarks Paraph 1/1/2011 Greasing and general servicing non Disinfection book Date of the Reason Specification Substance and Signature disinfection concentration Abbreviations used in column 2 (reason): V = Suspected infection IF = Infection case W = Repetition I = Inspection ƒ‰‡...
  • Page 26 Notes ........................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................
  • Page 27 Dealer´s stamp: Dealer´s stamp: Date: Date: Dealer´s stamp: Dealer´s stamp: Date: Date: Dealer´s stamp: Dealer´s stamp: Date: Date: For service checklists an additional technical information, please see our specialist dealers nearest to you. • More information on our website at: www.vermeiren.com.
  • Page 28 Notes ........................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................
  • Page 32 Fax: +41(0)31 818 40 98 website: www.reatime.it website: www.vermeiren.ch e-mail: info@reatime.it e-mail: info@vermeiren.ch Poland The Netherlands Vermeiren Polska Sp. z o.o Vermeiren Nederland B.V. Domstraat 50 Łączna NL-3864 PR Nijkerkerveen PL-55-100 Trzebnica Tel: +31(0)33 2536424 Tel: +48(0)71 387 42 00...

Table of Contents