Table of Contents
Advertisement
EN
NL
3.4.5 Adjustment of cross and backrest connection
The settings and item numbers can be found in following sections
Cross position (if adjustable)
1. Remove clip (10), at each side of the wheelchair.
2. Move the cross (X) forwards/backwards to the desired position according to the settings in
the tables of previous sections.
3. Replace both clips (10) at each side of the wheelchair to lock the cross position.
Backrest connection position
1. Demount both socket screws of the backrest connection, at both sides of the wheelchair.
2. Move the backrest connection (A/B/C/D) forwards/backwards to the desired position
according to the settings in the tables of previous sections.
3. Mount the 2 socket screws firmly; at both sides of the wheelchair.
4. Verify if seat height and seat angle are correctly set.
3.5
Parking brakes
CAUTION
Always adjust the parking brakes after adjusting the rear wheel position. Readjust also when tyres
are worn, to compensate the wear.
Adjust the correct braking force.
1. Release the brake with lever (21), see instruction manual.
2. Loosen socket screws (22) to make the brake free to slide.
3. Slide the brake over the guide (23) to the desired position.
4. Retighten the socket screws (22).
5. Verify if the brake is working properly: the wheel is blocked, but the brake can be operated
easily. If this is not the case, repeat the steps above.
6. Repeat this adjustment for the second parking brake. Make sure both brakes are adjusted
identically.
Cross position
10
X
1
2
3
Risk of injuries
4
Installation manual
- 12 -
V-series wheelchairs
Backrest position
1
2023-02
Adjustments
D
2
Advertisement
Table of Contents
