EN
NL
3.3.2 Adjusting rear and front wheel height
Adjust the rear wheel height as follows:
1. Remove the rear wheels (see instruction manual).
2. Demount the axle housings (E) of the rear wheels from the axle plate
(D) and remount in the correct hole, see tables in §3.3.1.
3. Repeat this for the second rear wheel. Make sure both housings are
positioned identically.
4. Verify that both axle housings (E) are tightened firmly.
Adjust the front wheel height as follows:
1. Remove the cover cap from the frame tube.
2. Remove the nut (31) of the swivel axle (F) and collect the loose parts.
3. Demount the front wheel and remount it in the correct hole of front fork (A)
according to the tables in §3.3.1.
4. Verify that the location of the bushing (B) is correct in relation to the swivel
axle housing (C), see tables in §3.3.1.
5. Mount the swivel axle (F) back in the housing (C) with bushing (B) at the
correct position, see the exploded view. Tighten nut (31) firmly.
6. Check the tension of the swivel axle (F); make sure it turns smoothly,
without play.
7. Repeat this for the second front wheel. Make sure both front wheels are
positioned identically.
Final adjustment
1. Insert the rear wheels.
2. If installed properly, the swivel axles of the front wheels stand perpendicular
to the ground. To adjust the angle of the swivel axles, follow the instructions
in the next section.
3. Finally, adjust the brakes according to the instructions in § 3.5.
Installation manual
- 8 -
V-series wheelchairs
2023-02
Adjustments
1
3
2
4
D
E
31
C
B
F
A