Installation And Adjustment; Tools; Manner Of Delivery; Adjusting The Seat Height And Seat Angle - Vermeiren V200D Instruction Manual

3

Installation and adjustment

The instructions in this chapter are for the specialist dealer.
The Vermeiren V200 has been designed to be adjust with a minimum of replacements parts.
There is no need for extra stock of spare parts.
To find a service facility or specialist dealer near you, contact the nearest Vermeiren facility.
A list of Vermeiren facilities can be found on the last page.
L
WARNING:
Risk of unsafe settings - Use only the settings described in this
manual.
L
WARNING:
Variation of allowed adjustments can still change the stability of your
wheelchair (tilt back or sideways).
3.1

Tools

To set up the wheelchair the following tools are needed.
Wrench set n° 7 to n° 22
Allen keyset n° 3 to n° 8
Screwdriver n° 4 to n° 5
Screwdriver Phillips head
3.2

Manner of delivery

The Vermeiren V200 shall be delivered with:
1 frame with arm supports, rear and front wheels (standard delivery
seat height: 500 mm (19.69 in.), seat angle: 5°)
1 pair footrests
Tools
Manual
Accessories
3.3

Adjusting the seat height and seat angle

The Vermeiren V200 is adjustable in 4 seat heights and 5 seat angles (0°-2,5°-5°-7,5°-10°)
by changing the position of the wheels for each height and angle there is a different setting
of the front and rear wheels.
The summary of the different seat heights by a standard seat angle 5° is tabulated below.
Seat height
Hole Position axle plate
440 mm 
(17.32 in.)

470 mm
(18.50 in.)

500 mm
(19.69 in.)
(Standard)

530 mm
(20.87 in.)
Rear wheels
Ⓓ
Above
Under
Under
Under
Table 2: Seat heights by seat angle 5°
Page 15
Front wheels
Hole Bushing Ⓑ
relative to castor
stem housing
 Above

Under

Under

Under
EN
V200
2011-01
Ⓒ