Table of Contents
Advertisement
Installation
IDE RAID Connectors: IDE3 & IDE4
The mainboard provides two extra IDE connectors (IDE3 & IDE4). This in
turn allows up to four extra IDE HDD connections. You can use these two
connectors for setting up RAID 0 or 1 array. If you want to connect two hard
disk drives to the RAID IDE connectors, you must always connect each hard
disk drive to two seperate IDE ribbon cables and you must set both hard disk
drives to master mode. For more information on setting RAID 0 or 1 array,
please refer to Appendix A of this manual. The RAID function can be disabled.
Please short pin 2 and 3 of RAID_DISABLE.
3
1
RAID_DISABLE
IDE 4
IDE 3
2-13
Advertisement
Table of Contents
