VIA Technologies P4PB ULTRA-URL User Manual page 47

SCSI
CD-ROM
HDD-1
HDD-2
HDD-3
ZIP100
LAN
Disabled
Boot Other Device
Enable the system to boot from other devices if the system fails to boot from
the First/Second/Third boot device. Settings: Enabled and Disabled.
Boot Up Floppy Seek
Set floppy seek during POST, BIOS will determine whether the floppy is 40 or
80 tracks. Settings: Enabled and Disabled.
Boot Up NumLock Status
Set the NumLock status when the system is powered on. "On" will turn key
pad into number keys, and "Off" will turn key pad into arrow keys. Settings: On
and Off.
Typematic Rate Setting
Set the typematic rate and delay. Settings: Enabled and Disabled.
Typematic Rate (Chars/Sec)
When Typematic Rate Setting is enabled. This item allows you to set the rate
(characters/second) at which the keys are accelerated. Settings: 6, 8, 10, 12,
15, 20, 24 and 30.
Typematic Delay (Msec)
When Typematic Rate Setting is enabled. This item allows you to select the
delay between when the key was first pressed and when the acceleration begins.
Settings: 250, 500, 750 and 1000.
The system will boot from SCSI.
The system will boot from CD-ROM.
The system will boot from second HDD.
The system will boot from third HDD.
The system will boot from fourth HDD.
The system will boot from ATAPI ZIP drive.
The system will boot from network drive.
Disable this sequence.
3-9
BIOS Setup