VIA Technologies P4PB ULTRA-URL User Manual page 45

Halt On
Determine the system behaviour if an error is detected at boot. Settings are:
All Errors
No Errors
All, But Keyboard
All, But Diskette
All, But Disk/Key
IDE Primary Master/Slave and Secondary Master/Slave
Press <Enter> to enter the sub-menu and the following screen appears:
The specifications of your drive must match with the drive table. The hard disk
will not work properly if you enter improper information for this category.
Select Auto whenever possible. If you select Manual, make sure the informa-
tion provided is from your hard disk vendor or system manufacturer.
IDE Primary Slave
Access Mode
Capacity
Cylinder
Head
Precomp
Landing Zone
Sector
PIO Mode
Ultra DMA Mode
System halts when any error is detected.
System does not halt for any error.
System halts for all error (except keyboard error).
System halts for all error (except diskette error).
System halts for all error (except disk/keyboard error)
The settings are None, Auto, Manual.
The settings are CHS, LBA, Large, Auto.
The formatted size of the storage device.
Number of cylinders.
Number of heads.
Write precompensation.
Cylinder location of the landing zone.
Number of sectors.
The settings are Mode 0/1/2/3/4, Auto.
The settings are Disabled and Auto.
3-7
BIOS Setup