Aerodr Battery Charger2; Aerodr Access Point; Image Processing Controller/Images - Konica Minolta AeroDR SYSTEM Operation Manual

5 .2 .11 AeroDR Battery Charger2

Status
Status LED (green) does not
light.
Error LED (orange) is on.
When the DR Detector is insert-
ed, the error LED (orange) lights.
Although the DR Detector is
inserted, charging does not start,
and the status LED (green) is out.
Although the DR Detector is
inserted, it cannot be registered,
and the status LED (green) is
flashing.

5 .2 .12 AeroDR Access Point

If a problem occurs in the AeroDR Access Point, contact Konica Minolta technical representatives.

5 .2 .13 Image processing controller/Images

Status
Transverse (noise) has gotten
into all images acquired from the
DR Detector.
Operation is normal, but prob-
lems can be seen with exposure
images.
Exposure cannot be confirmed in
image processing controller.
Error description
AC power not supplied.
The power switch is turned off.
-
DR Detector was inserted the wrong way.
The DR Detector is not inserted correctly.
AC power not supplied.
The power switch is turned off.
The Ethernet cable is disconnected.
Error description
The wired cable is not connected properly.
It has been occurring frequently since a cer-
tain time.
There is trouble in only 1 image.
The image processing controller does not
become Ready.
The icons of devices used on the image pro-
cessing controller are not displayed.
Make sure that the power cable is connected
correctly.
Turn on the power switch.
Contact Konica Minolta technical representa-
tives.
Check the insertion orientation of the DR
Detector.
Make sure that the DR Detector is inserted
correctly.
Make sure that the power cable is connected
correctly.
Turn on the power switch.
Make sure that the Ethernet cable is connect-
ed correctly.
Connect the wired cable spring connector unit
horizontally to the wired connector of the DR
Detector.
Perform calibration.
Check the exposure method and image pro-
cessing.
Check the image processing controller start
up.
Confirm that the icon of the device to be used
is displayed on the system monitor screen.
When the icon of the device is not displayed,
check that the device to be used is started. Or,
check that the Ethernet cable is properly con-
nected.
114
Corrective actions
Corrective actions