Konica Minolta AeroDR SYSTEM Operation Manual page 23

Table 1 (support for IEC 60601-1-2:2007 and IEC 60601-1-2:2014)
Guidelines and manufacture's declaration - electromagnetic emissions
This device is intended for use in the electromagnetic environment specified below.
The customer or the user of this device should assure that it is used in such an environment.
Emissions test Compliance
RF emissions
Group 1
CISPR 11
RF emissions
Class B
CISPR 11
Harmonic emissions
Class A
IEC 61000-3-2
Voltage fluctuations/
flicker emissions
Complies
IEC 61000-3-3
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
IMPORTANT
• If I/F Cable4 8mD and/or I/F Cable4 8mU is used, the emissions characteristics of this device is CISPR 11 class A
that is suitable for the industrial areas and the hospitals. If it is used in a residential environment, for which CISPR
11 class B is normally required, this equipment might not offer adequate protection to radio-frequency communica-
tion services, and it may be necessary to take a mitigation measures, for example, by relocating or re-orientating the
device.
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
Electromagnetic environment - guidelines
The device uses RF energy only for its internal function. Therefore, its RF
emissions are very low and are not likely to cause any interference in nearby
electronic equipment.
This device is suitable for use in all establishments including the following:
Domestic establishments and those directly connected to the public low-
voltage power supply network that supplies buildings for domestic purposes.
23
1.3 Safety precautions