Connecting Interface Cables To The Gr2000-B; Figure 4-42 Connection Of Primary, 10Base-T, Or 100Base-Tx Interface Cables; Figure 4-43 Connection Of Tertiary (T3) Interface Cables - Hitachi GR2000-B Series Installation Manual

Hitachi Gigabit Router GR2000-B Series Installation Guide
4.9

Connecting Interface Cables to the GR2000-B

Caution:
!
(1) Connecting Primary, 10BASE-T, or 100BASE-TX Interface Cables
Insert a connector and make sure it is locked.
Primary, 10BASE-T, or
100BASE-TX Interface Port

Figure 4-42 Connection of Primary, 10BASE-T, or 100BASE-TX Interface Cables

(2) Connecting Tertiary (T3) Interface Cables
Insert a connector by matching the projection of a receptacle and the groove of a
connector, and lock the cable by turning it clockwise.
Tertiary (T3) Interface Port

Figure 4-43 Connection of Tertiary (T3) Interface Cables

4-28
Incorrectly attaching a cable to an interface can severely damage the
GR2000-B. Read these instructions completely before connecting cables to
this device.
8-Pin Modular Connector (RJ-45)
BNC Connector
GR2K-GA-0007
Rev. 5.00