Attaching The Power Cable For The Gr2000-Bh; Figure 4-19 Location Of Power Switch; Figure 4-20 Locking The Power Cable Into Place (Gr2000-Bh) - Hitachi GR2000-B Series Installation Manual

Hitachi Gigabit Router GR2000-B Series Installation Guide
Step 3. As shown in Figure 4-19, make sure that the power switch is depressed in
the OFF (0) position and plug the other end of the cable into the AC outlet
you plan to use.
Power Switch

Figure 4-19 Location of Power Switch

Note: When pulling a cable out of the chassis connector, follow the procedures above
*
in reverse order.
4.5.2

Attaching the Power Cable for the GR2000-BH

Step 1. As shown in Figure 4-20, attach the power cable to the connector at the
back of a router.

Figure 4-20 Locking the Power Cable into Place (GR2000-BH)

4-16
Power Supply 1
Power Supply 0
Power Cable
ON
OFF
The locking metal bail
is not attached to prod-
ucts sold outside of
AC Connector
Metal bail to lock the power
cable in place (Japan only)
Note:
Japan.
GR2K-GA-0007
Rev. 5.00