Table of Contents
Advertisement
Step 2.
As shown in Figure 4-21 below, lock the power cable connector into place.
(Japan Only).
Figure 4-21 Locking the Power Cable into Place (GR2000-BH)
Note: When you have a dual-power system, you must attach separate power cables to
*
both power supplies 0 and 1.
Note: When pulling a cable out of the chassis connector, follow the procedures above
*
in reverse order.
Step 3.
As shown in Figure 4-22, make sure that both power switches are
depressed in the OFF (0) position and plug the other end of the cable into
the AC outlet you plan to use for each power supply.
Power Switch
Figure 4-22 Location of Power Switches on Rear Panel of GR2000-BH
GR2K-GA-0007
Rev. 5.00
ON
OFF
Power Switch for Power Supply 1
Power Switch for Power Supply 0
Setup
4-17
Advertisement
Table of Contents
