The powering options are controlled with jumper J2, as shown in
Figure 19: Jumper J2 powering options
J2 jumper settings are described in
Jumper position
P
N
F
Table 3 Jumper J2 settings
4.8 Mechanical specifications
EVB-ANT-1 Dimensions: 126.09 mm x 126.09 mm.
EVB-ANT-1 has four mounting holes that match the four corner holes on the ANT-Bxx antenna board
for screw mounting.
Figure 20: EVB-ANT-1 mechanical dimensions
UBX-22006906 - R03
C1-Public
Table
3.
Pins
Power setting
1–2
Power over Ethernet or barrel jack. When the barrel jack is present and
connected to a voltage source, the device automatically gives priority to
that, even if a PoE switch is also connected to the ethernet plug.
3–4
USB connector J15 (USB interface of the ANT-B10).
5–6
USB connector J13 (USB connector of the FTDI chip for UART connection
to the processors on EVB-ANT-1 or the antenna board).
Figure
19.
Page 22 of 44