Table of Contents
Advertisement
Figure 6: Updating the software on the board using s-center
3.1.3 Flashing from the Command line
Use the following procedure to flash the board over the UART connection.
1.
Download the u-connectLocate software container from the u-connectLocate product page
2.
Boot the board into Software Update mode by connecting the SWITCH_2 pin to ground while
powering up the board.
3.
Flash the u-connectLocate software using the bundled (Windows only)
Alternatively, use the Newt Manager Guide
Linux, and Windows.
4. Use Newt Manager to install u-connectLocate on the NINA-B411 module:
newtmgr --conntype=serial --connstring="COMXX,baud=115200" image upload <binary
image>
5.
Press the reset button to reset the application board or reset it with
newtmgr --conntype=serial --connstring="COMXX,baud=115200" reset
UBX-22006906 - R03
C1-Public
[6]
to install the
newtmgr
executable.
newtmgr
application tool for MAC OS,
:
newtmgr
Page 10 of 44
[4].
Advertisement
Table of Contents
