Table of Contents
Advertisement
From the configuration interface, you can:
•
Configure network settings for Wi-Fi and ethernet. The default IP address of EVB-ANT-1 is
192.168.1.102.
•
Send UDP packets containing angle events generated by the anchor. It is often convenient to
broadcast the address of the network, as shown in
•
Configure the active NINA-B411 module as either the NINA-B411 mounted on the ANT-B10 board
or the onboard NINA-B411 (connected to the custom antenna header).
Figure 18: Configuring the active NINA-B411 and destination for angle events
After updating the configuration, select Submit to send it to the MCU and save it to flash. Select Read
to retrieve current configuration.
4.6 Boot options
Use the SW3 DIP switches to set the board in regular boot mode or serial downloader mode, ss shown
in
Table
2.
Switch/Boot option
Boot from flash
Serial Downloader
Table 2 Boot options using SW3 switch
4.7 Powering options
EVB-ANT-1 is powered by either:
•
Power over Ethernet
•
An auxiliary jack (DC 9-57V)
•
USB type C (2 connectors available on the board)
UBX-22006906 - R03
C1-Public
Switch 1
Switch 2
Off
Off
Off
Off
Figure
18.
Switch 3
On
Off
Switch 4
Off
On
Page 21 of 44
Advertisement
Table of Contents
