Table of Contents
Advertisement
5.2 C209 Software and flashing
C209 tags are delivered with bootloader software only and do not include the tag software (available
from Github
[12])
The bootloader on C209 tags is different than that supplied on anchor nodes, and the nrfutil
flashing tool is needed to install software over the UART interface with the boot loader.
u-blox C209 tag software can be installed using the DFU bootloader or an external debugger.
Precompiled packages for each installation option are available from the u-blox C209 software
repository [12].
Figure 23: C209 with enclosure
5.2.1 Installing tag software with the DFU bootloader using s-center
The C209 tags can be flashed over the UART using s-center [7].
☞
Flashing requires s-center 6.1 or later.
Follow the flashing procedure outlined below when using s-center:
1.
Download and unzip the u-connectLocate software container, as described in
software with the DFU bootloader over the command
2.
Open s-center on the correct COM port once the module is in the software download mode.
3.
Select Software Update.
4.
In the "Software Update" dialog, select the
Figure
24. Make sure the flashing speed is set to 115200.
5.
Press Update.
UBX-22006906 - R03
C1-Public
needed for the device to advertise Bluetooth beacons to anchor nodes.
line.
file from the software container, as shown in
app.zip
[15]
Installing tag
Page 25 of 44
Advertisement
Table of Contents
