Powering Options; Mechanical Specifications - u-blox XPLR-AOA-3 User Manual

4.7 Powering options

EVB-ANT-1 is powered by either:
• Power over Ethernet
•
An auxiliary jack (DC 9-57V)
• USB type C (2 connectors available on the board)
The powering options for the platform are controlled with jumper J2, as shown in
Figure 20: Jumper J2 powering options
J2 jumper settings are described in
Jumper position
P
N
F
Table 3 Jumper J2 settings

4.8 Mechanical specifications

EVB-ANT-1 Dimensions: 126.09 mm x 126.09 mm.
EVB-ANT-1 has four mounting holes that match the four corner holes on the ANT-B family antenna
board for screw mounting, as shown in
UBX-22006906 - R07
C1-Public
Table 3.
Pins Power setting
1–2
Power over Ethernet or barrel jack. When the barrel jack is present and
connected to a voltage source, the device automatically gives priority to
that, even if a PoE switch is also connected to the ethernet plug.
3–4 USB connector J15 (USB interface of the ANT-B10).
5–6
USB connector J13 (USB connector of the FTDI chip for UART connection
to the processors on EVB-ANT-1 or the antenna board).
Figure 21.
EVB-ANT-1
XPLR-AOA-3 - User guide
Figure 20.
Page 21 of 46