Table of Contents
Advertisement
Installing the Device
2.3.2 Mounting the Device to a Panel
Removing the Device
To remove the device from a DIN rail, do the following:
1.
2.
3.
2.3.2
Mounting the Device to a Panel
To mount the device to a panel, do the following:
1.
8
Insert a flathead screwdriver into the slot of the sliding release and move it
down.
1
DIN Rail
1
DIN Rail Adapter
2
Figure 2.2
Removing the Device from a DIN Rail
Swing the bottom of the device away from the DIN rail.
Lift the device off the DIN rail.
Disassemble the device and panel adapter.
a.
Remove the screw at the bottom of the adapter.
b.
Pull the device out of the adapter.
2
Installation Manual, 11/2022, C79000-G8976-1009-10
3
1
2
1
RUGGEDCOM RMC40
Advertisement
Table of Contents
