Table of Contents
Advertisement
2.
3.
4.
2.4.2
Connecting DC Power
To connect a high or low DC power supply to the device, do the following:
Electrical hazard – risk of damage to equipment
Before testing the dielectric strength (HIPOT) in the field, remove the braided
ground cable connected to the surge ground terminal and chassis ground. This cable
RUGGEDCOM RMC40
Installation Manual, 11/2022, C79000-G8976-1009-10
1
2
3
Positive/Live (+/L) Terminal
1
Negative/Neutral (-/N) Terminal
2
Surge Ground Terminal
3
Braided Ground Cable
4
Figure 2.4
Terminal Block Wiring
Connect the negative wire from the power source to the negative/neutral (-/N)
terminal on the terminal block.
Using a braided wire or other appropriate grounding wire, connect the surge
ground terminal to the chassis ground connection. The surge ground terminal
is used as the ground conductor for all surge and transient suppression circuitry
internal to the unit.
Connect the ground terminal on the power source to the chassis ground
terminal on the device.
NOTICE
Installing the Device
2.4.2 Connecting DC Power
4
11
Advertisement
Table of Contents
Need help?
Do you have a question about the SIMATIC NET RUGGEDCOM RMC40 and is the answer not in the manual?
Questions and answers