ETC Source 4WRD Color II Installation And User Manual page 11

Install the Reflector Insert
When you use the Source 4WRD Color II with a Source Four fixture body,
you must install the reflector insert provided with the Source 4WRD Color II
in the Source Four fixture body.
CAUTION:
4WRD Color II retrofit. Using the reflector insert with an
incandescent Source Four lamp can result in damage to the
product.
1. Remove the shutter barrel from the fixture in order to access the
reflector housing.
Loosen the barrel rotation knob at the bottom of the reflector housing
and loosen the retaining bolt on the opposite side of the reflector
housing. Rotate the shutter barrel and remove it from the reflector
housing.
2. Place the reflector housing on a flat surface with the reflector facing
up.
Source 4WRD Color II Installation and User Manual
Use the reflector insert only with the Source
Retaining
bolt
Barrel
rotation knob
Reflector
housing
7