ETC Source 4WRD Color II Installation And User Manual page 10

Remove Incandescent Lamp Housing
1. Unplug the Source Four incandescent fixture and place it on a flat,
stable surface.
2. Loosen the brass thumb screw located above the beam adjustment
knob. The lamp housing is now loose.
3. Slide the lamp housing away from the fixture body and locate the
screw that secures the earth bond wire to the fixture body. Loosen
and remove the screw and accompanying washer to free the earth
bond wire.
4. Remove the lamp housing from the fixture body.
Note:
ETC to recycle the burner assembly, contact ETC Technical Services
for more information. See
page 2.
6
The burner assembly is no longer needed. If you would like
Source 4WRD Color II Installation and User Manual
Help from ETC Technical Services on